HEMI 90mm Throttle Body

The Arrington Billet 90mm drive-by-wire Throttle Body

---

Finally, a plug-and-play** replacement throttle body for your 2005 – Present 5.7 and 6.1 HEMI powered vehicles.

Our billet throttle body is made from T-6061 aerospace grade aluminum. They are fully CNC machined in house at Arrington Engines. Each one has a full 90mm bore, and is a direct bolt on replacement for the stock 80mm unit. These throttle bodies interface with the stock computer, no messy throttle cable or electronic alterations required. Best of all it’s made in the USA!

Orders are now being accepted. Each billet throttle body is individually numbered but quantities are limited so don’t miss out!

Price does not include a refundable core charge added at check-out.

**Tuning suggested/required. The throttle body should be calibrated to your vehicle by your local dealer. This unit flows 178 CFM over stock. A lean Air/Fuel ratio can cause catastrophic engine damage!

Add one of our HEMI Cold Air Intakes and a 5.7 - 6.1 HEMI Predator handheld Tuner for up to a 50 HP (Dyno Sheet) increase over stock on a 6.1 SRT8.

Specifications

---

• Direct, Bolt on Replacement throttle body for your 2005 – Present 5.7 and 6.1 HEMI powered vehicles
• Machined from T-6061, aerospace grade, billet aluminum
• Full 90mm bore
• 819cfm at Wide Open Throttle a full 178cfm over a stock 80mm throttle body
• Interfaces with the stock engine control computer (plug-and-play**)
• No throttle cable required
• Each billet throttle body is individually numbered and made in the USA

**Tuning suggested/required. The throttle body should be calibrated to your vehicle by your local dealer. This unit flows 178 CFM over stock. A lean Air/Fuel ratio can cause catastrophic engine damage!