Gauge Kits and Accessories

Diablosport Gauge Pod Mount for Trinity Tuners: The DiabloSport Trinity Gauge Pod Mount is a universal mount specifically designed to fit any 2 1/16th gauge pod. The Gauge Pod Mount locks into the back of the Trinity and allows a full 360 degree adjustment.  

Innovate Motorsports 18 ft sensor extention cable for the LM-2 and MTX-L. 

This custom 6" cable will allow you to connect and/or daisy chain the following products: XD-16, LC-1, LMA-3, DL-32, SSI-4, TC-4, & ST-12. Also used to connect the LM-1 to the XD-16. 

Wall AC power adapter for Innovate Motorsports LM-1 meter only. 

Auto Timer / Wideband Display Kit, Includes: Auto Timer, LC-1 Wideband Kit with O2 (P/N: 3769). Designed to prolong the life of your turbocharger and/or oil. The Innovate Motorsports Auto Timer will allow a vehicle to idle the engine for a timed period, with the ignition key removed. This conveniently allows the engine oil and turbo center cartridge to cool down properly and prolong turbo and oil life. This can be done by two programmable count down presets, or you can use its three auto... 

The AuxBox attaches to the auxiliary input of the LM-1 or it can be integrated into the MTS serial chain. The AuxBox has 5 built-in sensors. The 5 internal sensors are: Manifold Air Pressure (MAP or Boost), Cylinder Head Temperature (CHT) or Exhaust Gas Temperature (EGT), RPM conversion (from a tach signal or inductive clamp), Acceleration, and Injector Duty Cycle (or Dwell). The internal MAP sensor is a 3-bar absolute pressure sensor, providing accurate data up to 44.1 PSIA. The temperature... 

This custom cable will allow you to connect and/or daisy chain the following products: XD-16, LC-1, LMA-3, DL-32, SSI-4, TC-4, & ST-12. Also used to connect the LM-1 to the XD-16. 

This custom cable will allow you to connect and/or daisy chain the following products: XD-16, LC-1, LMA-3, DL-32, SSI-4, TC-4, & ST-12. Also used to connect the LM-1 to the XD-16. 

Innovate Motorsports carrying case for LM-2 digital air/fuel ratio meter (Black). 

This kit comes complete with the patented award-winning LC-1 Wideband Controller, DB-Blue Gauge, Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide. 

This kit comes complete with the patented award-winning LC-1 Wideband Controller, DB-Red Gauge, Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide.  

The new Innovate Motorsports Digital MTX Series Air/Fuel Ratio Gauge utilizes the only 100% digital Wideband air/fuel ratio technology on the market! The award-winning patented DirectDigital™ technology we use is faster and more accurate than common “UEGO” gauges and is now more affordable! In addition, the gauge features a water resistant casing, interchangeable faceplates and bezels, and 2 fully programmable linear analog outputs for use with aftermarket engine managements systems... 

Innovate Motorsports MTX-L (Powersports) Complete All-In-One Air/Fuel Ratio Gauge Kit. Includes: Gauge, Silver Bezel, Black Bezel, White Faceplate, Black Faceplate, Bosch O2 Sensor, 3ft. Sensor Cable (Overall length 4.5ft.), Exhaust Bung, Program Cable (Only needed for Datalogging and to change the Fuel Type Setting), Software CD, and Quick Start Guide. The new Innovate Motorsports Digital MTX Series Air/Fuel Ratio Gauge utilizes the only 100% digital Wideband air/fuel ratio technology on... 

The DL-32 is a complete vehicle-mounted data-logging system for advanced engine tuning. The system is anchored by Innovate's award-winning digital wideband air/fuel ratio technology, but also includes flexible sensors for RPM, MAP, temperature, duty cycle, and analog inputs. The DL-32 kit includes the DL-32, mounting hardware, SD memory card, cd which includes software and manuals, quick start guide, MTS 2.5mm to 2.5mm male cable, and a push button and LED. 

The new Innovate Motorsports MTX Digital Series Exhaust Gas Temperature (EGT) gauge is now available! This 2 1/16” (52mm) gauge features a water resistant casing, interchangeable faceplates and bezels, locking connectors for simplified installation, and MTS serial connections used to connect with other Innovate devices for logging to your PC, iPhone, iPod Touch, iPad, LM-2, or DL-32. (OT-2 for logging to your Apple device not included. LogWorks Mobile v1.13+ required, coming soon.)  

This kit comes complete with the patented award-winning LC-1 Wideband Controller, G2 Gauge, Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide. 

This kit comes complete with the patented award-winning LC-1 Wideband Controller, G3 Gauge, Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide. 

This kit comes complete with the patented award-winning LC-1 Wideband Controller, G4 Gauge (2 1/16", 52mm), Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide. 

This kit comes complete with the patented award-winning LC-1 Wideband Controller, G5 Gauge (2 1/16", 52mm), Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide.  

The LC1-Duo Kit consists of 2 LC-1s (one for each bank), and a DL-32. This kit is ideal for most forms of racing, and offers a savings of nearly $100 vs. when purchased separately. 

The LC-1 is a complete wideband controller built in to a sealed cable. It features the same award-winning patented digital measurement principal found in the LM-1, and includes digital input, output, and 2 programmable analog outputs. 

The Innovate Motorsports LC1+ kit includes an LC-1 wideband controller with O2 sensor, plus an SSI-4 multi-sensor interface. Used in conjunction with LogWorks, running on a laptop or PC, this setup allows you to record and analyze 5 channels of data. These channels are Air/Fuel Ratio, and any four of the following: RPM, Injector Pulse Width, Throttle Position, Driveshaft/Wheel Speed, or Boost/Vacuum. All channels can be configured for external 0-5V or frequency. 

Innovate Motorsports 3 ft sensor extention cable for the LM-2 and MTX-L. 

Analog input and output accessory cable for LM-2 (Needed for RPM Input). 

The new LM-2 "Basic" Kit (Single Wideband O2) ONLY includes the LM-2 meter, Bosch wide-band oxygen sensor, 8 ft sensor cable, cigarette-lighter power adapter, USB cable for PC connection, weld-in bung and plug, LogWorks software CD, and quick-start guide. *Note: The LM-2 "Basic" Kit out of the box only includes accessories to display your Air/Fuel Ratio either on the meter and/or on your PC. To log RPM, or to Output the wideband signal to an external device you'll need the LM-2 Analog IN/OUT... 

The Innovate Motorsports LM-2 Kit (Single Wideband O2) includes the LM-2 meter, Bosch wide-band oxygen sensor, 8 ft sensor cable, cigarette-lighter power adapter, analog in/out cable, ODB-II/CAN interface cable, SD memory card, USB cable for PC connection, weld-in bung and plug, LogWorks software CD, and quick-start guide. Carrying Case also included! 

Innovate Motorsports OBD-II / CAN Interface Accessory Cable for LM-2. 

The Innovate Motorsports LM-2 Kit (Single Wideband O2) includes the LM-2 meter, Bosch wide-band oxygen sensor, 8 ft sensor cable, cigarette-lighter power adapter, analog in/out cable, ODB-II/CAN interface cable, SD memory card, USB cable for PC connection, weld-in bung and plug, LogWorks software CD, and quick-start guide. Carrying Case also included! 

LM-2 Serial Patch Cable makes the LM-2 MTS Compatible (LC-1, LMA-3, DL-32, SSI-4, TC-4). Four pin Molex to serial 2.5mm. Not included with LM-2 kit. 

Replacement USB Cable for LM-2. Included in LM-2 kits. 

MTX-D: MTX Digital Series Oil Pressure & Temperature Gauge Kit - P/N: 3852. The new Innovate Motorsports MTX Digital Series “Dual Function” Oil Pressure & Temperature Gauge is now available! That’s right! One gauge, TWO functions! In addition, the 2 1/16” (52mm) gauge features a water resistant casing, interchangeable faceplates and bezels, locking connectors for simplified installation, and MTS serial connections used to connect with other Innovate devices for logging to your PC,... 

The new Innovate Motorsports MTX Digital Series “Dual Function” Vacuum/Boost & Shift Light (RPM) is now available! One gauge with TWO functions! That’s the perfect solution to help maximize limited space on your dash! The 2 1/16” (52mm) gauge features a water resistant casing, interchangeable faceplates and bezels, locking connectors for simplified installation, and MTS serial connections used to connect with other Innovate devices for logging to your PC, iPhone, iPod Touch, iPad,... 

The new Innovate Motorsports MTX Digital Series “Dual Function” Water Temperature & Battery Voltage. This “Dual Function” gauge is the perfect way to monitor critical engine parameters on one display. The 2 1/16” (52mm) gauge features a water resistant casing, interchangeable faceplates and bezels, locking connectors for simplified installation, and MTS serial connections used to connect with other Innovate devices for logging to your PC, iPhone, iPod Touch, iPad, LM-2, or DL-32. (OT-2... 

The Serial Program Cable will allow you to connect the MTX-L and LM-2 to your PC. 

"LogWorks" Mobile App download in Apple iTunes, free of charge. The OT-2 is an OBD-II vehicle interface for Apple TM iPhone TM or iPod Touch TM and includes software performance computer, efficiency calculator, and advanced diagnostics.Turn your iPhone into a wireless gauge and data logger! The OT-2 Gauge allows you to view and record your choice of critical engine information such as RPM, TPS, MAP, IAT, and timing advance and more! Share your data by emailing your logs instantly to friends,... 

Innovate Motorsports 10-ft. long, for direct connection on LM-1 to cigarette lighter or accessory plug. LM-1 only. 

Innovate Motorsports replacement Power Cable. Included with LM-2 kit. 

Innovate Motorsports replacement 8ft Sensor Cable. Included in LM-2 kits. 

The Serial Program Cable will allow you to connect any of the following devices to your PC; Innovate Motorsports LC-1, XD-16, LMA-3, DL-32, SSI-4, or TC-4. 

The SSI-4 is also a key component of Innovate Motorsports' Modular Tuning System (MTS). Using the SSI-4's serial ports you can daisy-chain other Innovate devices such as the XD-16, AuxBox (LMA-3), LC-1, DL-32, and TC-4. 

The TC-4 includes the TC-4, Program Cable, Patch Cable (to daisy chain with other MTS compatible devices), Mounting hardware, and cd which includes software and manuals. 

Adapter for computers without Serial ports. This cable will convert Serial to USB so that you can connect select Innovate Motorsports products to your computer. Hardware drivers included.